This is the Power house for the system. It converts the power from your GFI Outlet into useable electricity for the bulb in the water. It also contains all of the wiring, and photocell unit. This piece of the assembly comes prewired, and all you need to do for installation is screw it into your bulkhead, or wherever you want to mount it. The powercord, and the conduit from the Bulb & Housing run out of the bottom of the Junction Box. See Pictures Below!
clickfor larger images

Front View	This shows how the Junction Box looks from the front. You can see the Photo Cell on the top, and the powercord, and conduit leaving the box in the lower corner. The Unit stands 6 inches tall and 6 inches wide. We have found that it fits almost all pylons very easily!
Ballast View	This view shows how the junction box looks from a side angle. It sticks out approximately 4 inches from your pier. This aluminum unit prevents water from entering transformer area, and also allows air circulation via aluminum skirt around main housing unit.
Side View	Often we hook up multiple units and allow for multiple lights to be put in the water. They are all wired together to a single plug, so it makes it very easy.
Looking Down	Here is a view looking down the bulkhead into the water. You can see the three (3) pipes entering the water. Each pipe runs into the water, and then elbow joints out to a light that sits at variable heights above the bottom of your waterway. The pipe comes up into the transformer box housing and is air tight,and prevents hooks or penetration of any kind.